![]() Conclusion | Creating a Path Between Nodes in Workbench ![]() Many paths can be created, and for any given path, many linearized results can be defined and observed. ![]() The results of the path linearization can be observed, and optionally promoted to parameters, as needed: With a path for data mapping chosen, right-click at the Solution branch, and choose “Evaluate All Results” to see the linearized stress plot and data. The Path of interest can be chosen by name from a drop-down list in the Details for the linearized result: Linearized StressĪ linearized stress can be inserted below the Solution branch for an environment of interest. Once the path exists, results of interest can be mapped onto the path for postprocessing purposes, including linearized results that may be of interest when satisfying design codes. The path should appear as desired, travelling between two nodes on exterior faces of the model: Now click close to the location of interest for the End point, right-click and choose “Snap to Mesh Nodes”, and go back to the Location box and click the Apply button. Click on the Location box for the End point so that Apply appears: Now repeat for the node at the other end of the path. Then, click the Apply button for the Start point: Rotate and zoom the model so that the element faces where the first node is to be chosen are visible, as illustrated below.Ĭlick very close to the first node to be chosen, zooming as required:Īfter clicking on the location on the surface, right-click the mouse, and select “Snap to mesh nodes”… Then, go to the graphics window to click on a location for the first point on the path. How to Rotate a Model so an Element Faces the First Node | Ansys Workbench The “Click to Change” box changes to provide an Apply button: First the Location of the Start is chosen: A toolbar icon can be used to select locations on faces in the model:Įach of the two points can be defined in turn. “Two Points” typically selects two vertices. That requires definition of the Start and the End points for the path: The path should be named appropriately.īefore proceeding, if the use of two nodes to define a Path is wanted, it helps to make the mesh visible:Īfter clicking on the Path entry in Construction Geometry, a Path Type based on “Two Points” can be selected. The user must enter Details for a new Path to complete its definition. One or more Paths or Surfaces can be inserted into the Construction Geometry branch: To start with creation of a Path (between nodes), a model needs a Construction Geometry branch: The Two Points approach can use vertices, or model face locations. Industrial Equipment and Rotating MachineryĬreating a Path for Results Review in Ansys Mechanical WorkbenchĪ user can place a Path along an Edge in WB Mechanical, or between two points.Torsional Vibration Measurements Testing. ![]() Fluid Flow & Thermal Applications (CFD).Electronic and Electrical Applications (EM). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |